Description

• Sand vac replacement accessory
• Fits Pentair Cristal-Flo II, Waterford pool and spa filters
• This sand vac empties a sand filter in 10-minutes for repair, refilling or removal
• Measures 20-inch length by 3-inch height by 19-3/4-inch width

THE SAND-VAC SYSTEM

Equipment Provided:

1. The Sand-Vac Head
2. 9 ft of 1-1/AExhaust Hose
3. As ft of 1-1/A” Exhaust Hose
4. Instructions
5. Storage Box

Additional Eguioment Needed:

1. 5/8″ or larger Garden Hose
2. water Supply with Normal Household Pressure

SAND-VAC Operating Instructions

1. Remove the filter tank’s filling port cover.
2. If a side-mounted multi-port valve is present, set it to the CLOSED position.
3. Fill the filter tank to the top with water.
4. Connect one end of a 5/8″ or larger garden hose to the SAND-VAC and attach the other end to any standard water supply.
5. Connect the 1%” exhaust hose to the SAND-VAC exhaust port. (Connect tightly with a “twisting” motion) If sand is to be exhausted into a bucket, use the bft. exhaust hose. If the sand lS to be spread onto a nearby area, use the 9 ft. exhaust hose
6. Insert the SAND-VAC through the tank’s filling port, into the filter and push the scoop gently into the sand bed.
7. Place the loose end of the exhaust hose in the desired exhaust location. Be sure that once the exhaust hose leaves the filter tank that it continuously slopes downward. Any upward slope will cause sand to build up in the exhaust hose and reduce the efficiency of the SAND-VAC significantly.
8. Be sure that neither the water supply hose nor the exhaust hose is kinked.
9. Turn on the water supply.
10. The SAND-VAC will normally partially prime itself. However a partial prime reduces the efficiency of the SAND-VAC system drastically. To accomplish a full prime, lift the exhaust hose so that it is at the level of the water surface in the filter tank. Be sure that all air bubbleS are out of the hose, then lower the hose quickly to the desired exhaust area.
11. Stir the sand bed gently with your hand keeping the SAND-VAC scoop covered with sand. Keep sand at the opening at all times by moving either the SAND-VAC or the sand, or both, as needed.
12. If a bucket is being used to collect the sand, turn off the water supply and empty the bucket as needed.
13. If the filter tank empties of water before all sand is re moved, stop operation of the SAND-VAC and refill the filter with water. Once an adequate water level is re-established, resume operation of the SAND-VAC.
14. When sand removal is complete, position the SAND-VAC at the bottom of the filter and turn off the water supply. The SAND- VAC will now empty the remaining water in the filter tank.
15. When the filter tank is empty of both sand and water remove the SAND-VAC, clean the exhaust hose, and store the equipment in its box.
16. The filter tank is now ready for repair, refilling, or removal.