Description

INYO # 3783-300 WATERWAY # 642-4700V THIS IS COMPLIANT WITH THE ASME/ANSI A112.19.8-2007 REGULATIONS AS SPECIFIED BY THE VIRGINIA GRAEME BAKER POOL AND SPA SAFETY ACT THIS IS A VGB-2008 COMPLIANT COVER

************************************************

GENERAL DESCRIPTION: 9″X 9″ SQUARE RETROFIT MAIN DRAIN COVER, WHITE

************************************************

BASIC SPECS: SCREW HOLES: 1 IN THE CENTER OF EACH SIDE 2 OF THE SIDES HAVE 3 HOLES WITH 1 IN THE CENTER SEE BELOW FOR DETAILS USAGE: APPROVED FOR FLOOR OR WALL USAGE SPECS: SPECS SHOWN ARE FOR A SINGLE UNIT FLOOR: 289 GPM @ 2.33 FPS WALL: 198 GPM @ 1.59 FPS LIFE: 7 YEARS TOTAL OPENING: 39.9 SQ INCH 186 GPM @ 1.5 FPS

************************************************

DETAILED DESCRIPTION: THIS IS A 9″ X 9″ SQUARE REPLACEMENT COVER THIS IS AN ANTI-ENTRAPMENT RETROFIT COVER AND SCREWS THIS HAS SCREW HOLES DESIGNED TO LET IT REPLACE A WATERWAY, HAYWARD OR PENTAIR 9″ X 9″ SQUARE COVER THIS HAS A REGULAR GRATED SHAPE BUT THE COVER SLOPES UPWARD FROM THE OUTSIDE TOWARD THE CENTER. EACH SIDE HAS A SQUARE NOTCH AT THE BOTTOM MATERIAL: PLASTIC COVER COLOR: WHITE SHAPE: SQUARE

************************************************

COVER DIMENSIONS: COVER LENGTH WIDTH: 8-13/16″ (A) HEIGHT: 1″ (AT THE OUTSIDE EDGE) MAXIMUM HEIGHT: 2-1/4″ (AT THE CENTER OF THE COVER) (B) MAXIMUM HEIGHT ABOVE PLASTER LINE: 1-1/4″ (THE COVER IS FLUSH WITH A STANDARD 1″ DEEP FRAME AT THE EDGE)

************************************************

SCREW HOLES: THE COVER HAS SCREWS PLACED SO THE COVER WILL MATCH THE OLDER STANDARD WATERWAY, AND THE PENTAIR AND HAYWARD OLDER AND CURRENT FRAMES THERE IS ALSO AN 11/16″ DEEP NOTCH, 1/2″ WIDE IN THE CENTER OF EACH SIDE THE CENTERLINE OF EACH SCREW HOLE IS 5/16″ FROM THE OUTSIDE EDGE OF THE COVER FROM THE CENTERLINE OF EACH SCREW HOLE TO THE CENTERLINE OF THE SCREW HOLE ON THE OPPOSITE SIDE IS 11-3/16″. SCREW HOLE PLACEMENT: TOTAL SCREW HOLES – 8 THERE IS ONE SCREW HOLE IN THE CENTER OF EACH SIDE 2 OF THE SIDES HAVE AN ADDITIONAL 2 SCREWS EACH OF THESE IS 2-7/8″ FROM THE CENTER HOLE MEASURED CENTER TO CENTER

************************************************

SCREWS: THERE ARE NO SCREWS INCLUDED WITH THIS COVER

************************************************

MARKINGS: 640-470X V IS MOLDED INTO THE TOP OF THE COVER AT THE EDGE THE SPECS REQUIRED BY THE VGB-2008 LAW ARE ALSO MOLDED ON THE COVER